2020 INFINITI Q60 - Windshield Wiper and Washer Controls

"This video is copyrighted material of Nissan North America, Inc. and should not be copied, edited, or reproduced without the permission of Nissan.

Your vehicle is equipped with either intermittent wipers or the Rain Sensing Auto Wiper System. If your vehicle is not equipped with the Rain Sensing Auto Wiper System, please see your Owner’s Manual for more information.

The Rain Sensing Auto Wiper System automatically turns on the wipers and adjusts the wiper speed depending on rainfall and vehicle speed.

This is the lever used to control the wiper system.

To set the Rain Sensing Auto Wiper System, make sure the ignition switch is in the ON position and then push the lever down to the AUTO position. The wiper will sweep once.

To adjust the sensitivity of the rain sensor, turn THIS knob.

Be aware that even if it starts to rain, the wipers may not begin to function if the rain is not directly hitting the rain sensor.

To turn the system off, push the lever up to this position. For constant wiper speed, pull the lever down to the LO or HI position.

In conditions of mist or light rain, push the lever up to MIST and you will get a one-sweep operation of the wipers.

To clean the windshield, pull the lever toward you and hold. Washer fluid will spray and the wipers will automatically sweep several times. The wiper then will operate
approximately once every three seconds for a period of time in order to remove water or washer fluid that has dripped on the windshield. To enable or disable this feature:
● Press the MENU button on the control panel,
● Touch SETTINGS on the lower touch screen display,
● Touch COMFORT AND CONVENIENCE, then
● DRIP WIPE

To replace the wiper blades or clean the lower windshield, the windshield wipers must be in the service position. Place the ignition in the OFF position and within one minute push the windshield wiper lever up twice within .5 seconds. The wiper operation stops in mid-operation. The wiper arm can then be pulled away from the windshield for replacement or cleaning. To return the wiper blades to the original position, push the lever down to operate the wipers at any speed.

Please see your Owner’s Manual for important safety information, system limitations, and additional operating and feature information."
DETAIL_ADS